Garage Door Prices in Perth
Every price we quote from, in one place: repairs, springs, cables, motors, remotes, servicing and new doors. GST included, fixed quote before any work starts, and no call-out fee.
In Perth, one garage door spring costs $260–$340 fitted, a replacement motor $750–$1,150, a full service from $160 plus parts, and a new standard garage door $2,200–$5,500installed. Those are our own ranges, GST included. Your door's size, type and the parts it needs decide where in the range the job lands, and we confirm the exact figure as a fixed quote before any work starts. There is no call-out fee.
Garage door repair prices
Supplied and fitted, on the day where the part is on the van. The low end is a straightforward job on a standard single door; the high end is a heavy, insulated or double door, or awkward access.
| Job | Price (GST incl.) | What it covers |
|---|---|---|
| Broken spring(s) | $260–$1,100 | New torsion or extension springs fitted and tensioned on the day, with the door's balance checked before we leave. |
| Spring re-fit / re-tension | $220–$320 | Your existing springs re-seated and re-tensioned when nothing has actually snapped. |
| Cable snapped or off the drum | $260–$520 | Lift cables replaced or re-seated on the drums, then the door re-balanced and tested. |
| Motor / opener not working (repair) | $250–$480 | Fault-finding and repair of the opener itself — drive gears, limit switches, capacitor or control board. |
| Door off track / stuck | $380–$750 | The door put back on its tracks, the tracks straightened and any damaged rollers replaced. |
| Door damaged (panel / section) | $450–$1,200 | A damaged panel or section repaired or replaced, with the hinges and rollers around it checked. |
| Hinges & rollers / wheels | $35 each + $150 labour | Worn hinges and rollers replaced at $35 per part, plus one $150 labour charge for the visit. |
| Roller door lock + arms | $320–$450 | The roller-door lock and its lock arms replaced and keyed. |
| Pelmet / hood replaced | $350–$520 | The roller-door pelmet (hood) replaced, colour-matched where the colour is still made. |
| Weather seal (rubber & brush) | $220–$450 | Bottom rubber and side brush seals fitted to keep out water, sand, dust and pests. |
| Safety sensors / photo eyes | $160–$320 | Safety photo-eye sensors replaced and aligned so the door stops and reverses the way it should. |
Garage door motor, opener and remote prices
A replacement opener includes the motor, fitting, programming and remotes. Repairs are quoted after we have seen what has failed inside the unit.
| Job | Price (GST incl.) | What it covers |
|---|---|---|
| Motor / opener replacement | $750–$1,150 | A new opener supplied, fitted and programmed, with remotes included. |
| WiFi / smart control (supply & install) | $250–$420 | Wi-Fi / smartphone control added to a compatible opener. |
| Remote (extra / replacement) | $85 each + $110 to attend & program | Genuine remotes at $85 each, plus $110 to attend and code them to your motor. |
Garage door service and inspection prices
A service covers lubrication, balance, tracks, hardware and the safety reverse. Any part the door needs is quoted on the spot and only fitted if you say yes.
| Job | Price (GST incl.) | What it covers |
|---|---|---|
| Service / tune-up | From $160 + parts | A full service — lubrication, balance, track and hardware checks and safety adjustment — for $160 plus any parts the door needs. |
| Safety check-up / inspection | $130 | A safety inspection with a written report — $130. |
New garage door and installation prices
A new door is priced to the opening, the door type and the material, so these are wide bands. Removal of the old door and new tracks and hardware are included in every install we quote.
| Job | Price (GST incl.) | What it covers |
|---|---|---|
| New garage door — standard (supply & install) | $2,200–$5,500 | A new sectional or roller door supplied and installed, with the old door removed and new tracks and hardware included. |
| New door — commercial / custom | From $5,500 | Commercial, oversized and custom doors supplied and installed to your opening and your specification. |
| Tilt-door arms kit + springs | $1,100–$1,900 | A replacement tilt-door arms kit with new springs, fitted to your existing door. |
| Roller door removal & reinstall | $800–$1,400 | Your roller door taken down and refitted after rendering, painting or building work. |
| Sectional door removal & reinstall | $900–$1,400 | Your sectional door removed and reinstalled, with the tracks realigned. |
| Commercial roller door (service, from) | $320–$480 | A service or minor repair on a commercial roller door. A new commercial door is quoted separately. |
What moves a garage door price up or down
Door type and size
A double sectional door carries heavier springs, longer cables and a stronger motor than a single roller door, so the same fault costs more to fix on it.
The part itself
Genuine Merlin, B&D, Steel-Line and Centurion parts cost more than generic ones, and a discontinued panel colour or profile can force a bigger replacement than the damage suggests.
How many parts
Springs on a double door are replaced as a matched pair ($460–$600) so the door lifts evenly; rollers and remotes are priced per item plus one labour charge.
Access and condition
A door that has dropped, jammed or bent its tracks takes longer to make safe before the repair starts. Tight rear-access garages and high openings add time too.
Time of day
The ranges here are daytime prices. An after-hours or emergency job may cost more, and we confirm the exact figure before anyone drives out.
Residential or commercial
Commercial roller doors and sectional doors are bigger, heavier and often need high-cycle parts, which is why new commercial doors start from $5,500.
Repair or replace?
A single failed part on a structurally sound door is worth repairing: a spring, a cable, a set of rollers or a motor costs a fraction of a new door and gives the door years more service. We recommend a new door when the panels are rusted through or damaged across several sections, when parts for an old make are no longer available, or when the door has needed three or four repairs in a couple of years and the next one would cost more than the door is worth.
Where it is a close call we say so and quote both ways — garage door repairs against a new garage door — and the decision is yours. Our guide to repairing or replacing a garage door walks through the signs.
How we quote
- 1
Tell us what the door is doing
A call or a photo is enough. We ask the door type, the brand of motor if there is one, and what you can see or hear.
- 2
You get a range on the phone
The ranges on this page, narrowed to your door. If the job is after hours, we tell you the exact figure then and there.
- 3
The technician inspects and fixes the price
On site the range becomes one fixed figure, GST included, with the parts named. Quoting is free and there is no call-out fee.
- 4
Work starts only once you agree
Most repairs finish the same visit because the vans carry springs, cables, rollers and the usual opener parts, and remotes are coded on the spot ($85 each + $110 to attend & program).
Detailed cost guides
One job at a time: what is included, what moves the price, worked examples and when a replacement beats a repair.
Frequently Asked Questions
Most repairs land between $260 and $750, GST included. A single broken spring is $260–$340 fitted, a snapped or slipped cable $260–$520, a door off its tracks $380–$750, and an opener repair $250–$480. The exact figure is confirmed as a fixed quote before any work starts.
A new opener supplied, fitted and programmed with remotes is $750–$1,150. Belt-drive, battery-backup and smart units sit at the top of that band. If the fault is a gear, capacitor or board rather than the whole unit, a repair is $250–$480, and we tell you which makes sense once we have seen the motor.
A standard new sectional or roller door is $2,200–$5,500 supplied and installed, including removal of the old door and new tracks and hardware. Commercial, oversized and custom doors start from $5,500 and are quoted to the opening. Size, material, insulation and whether a motor is included are what move a door's price.
A full service is from $160 plus any parts the door needs, and a safety inspection with a written report is $130. Lubrication, balance, tracks, rollers, hinges and the safety reverse are all checked, and anything worn is quoted before it is fitted.
No. There is no call-out fee at any hour, anywhere in Perth. You pay for the work you agree to, at the price we confirm before we start, and nothing else. Quotes are free.
Yes. Every figure on this page and on our service pages includes GST, so the range you read is the range you pay. There are no hidden fees added at the end.
They can. The ranges here are daytime prices, and an after-hours or emergency job may cost more because of the hour — but we tell you the exact figure on the phone before anyone drives out, and there is still no call-out fee.
Because the same fault costs different amounts on different doors. The spring for a light single roller door and the spring for a heavy insulated double door are different parts at different prices, which is why one spring is $260–$340 and a matched pair $460–$600. The technician narrows the range to one fixed figure on site, before any work begins.
Want the exact price for your door?
Call with the door type and what it is doing, or send a photo, and we'll give you the range now and a fixed quote on site. GST included, no call-out fee, work only once you agree.